1、开启电源，检查压纹机托板位置，开启电脑，然后将托板位置归零 1, open the power supply, check the embossing machine pallet position, turn on the computer, and then the pallet position to zero 2、将深压纹机的加热系统打开，设置压纹机所需要的温度，提前打开温度 2. Turn on the heating system of the deep embossing machine, set the temperature needed by the embossing machine, and open the temperature ahead of time 3、检查所有的机械结构件是否在规定位置，将所有机械位置复位 3. Check whether all the mechanical structural parts are in the specified position and reset all the mechanical positions 4、观看压纹机工作台内是否有异物，有异物需要及时清理，是否已经有压纹版 4, watch the embossing machine workbench whether there are foreign bodies, foreign bodies need to clean up in time, whether there has been embossed version 5、打开液压油泵，查看油泵皮带是否松动，同时，手工将压纹机横梁升至最高处 5, open the hydraulic pump, to see whether the oil pump belt is loose, and at the same time manually press the stria machine crossbeam to the highest place 6、手工检查压纹机保护光幕是否正常，保护光幕是保护操作工人安全的，这一点非常重要 6, manual inspection embossing fangdaomen.89ix.comdiankonggui.89ix.com tiepuyi.89ix.comtanceqi.07858.net bianyaqiyj.37ix.com.cngangguanh.37ix.com.cnmachine protective screen is normal, the protection of the screen is to protect the safety of operators, this is a very important point 7、液压系统一旦打开，就要开启压纹机冷却系统，特象机械深压纹机采用风冷，操作简单方便，按钮一下就可以了 7, once the hydraulic system is opened, it is necessary to open the embossing machine cooling system, especially mechanical deep embossing machine, using air-cooled, simple and convenient operation, the button on it 8、装好深压纹版，同时灰纸板底模也做好，等压制十分钟将胶水固化的时候就可以校正套印精度，随机试验两张，如果套印没有问题，压纹版深浅没有问题的话就可以正常生产了! 8, installed deep embossed version, while gray cardboard bottom die well, press ten minutes when the curing of the glue can be corrected overprinter precision, randomized trial of two, if the set is no problem, no problem depth embossed version would be normal production!