如果压纹机底座不牢固，即使安装时已做了准确的水平校正，但一段时间的运转后基础水平也必将因机器振荡破坏出现变异情况，机器偏斜而导致运行不稳定，从而影响压纹产品质量。
If the base of the embossing machine is not firm, even if the correct level correction has been made during installation, after a period of operation, the basic level will also change due to machine oscillation damage, which will lead to unstable operation, thus affecting the quality of embossing products.
若机器是放在底层出版动态，需要扎地基时，除考虑机器自重外，还要考虑机器运转时传递到地基上的动载荷，以及车间所在地质的软硬程度，以防止机座下沉变形。
If the machine is placed on the bottom of the publishing dynamic, when the foundation needs to be laid, in addition to considering the weight of the machine, but also consider the dynamic load transferred to the foundation when the machine is running, as well as the geological hardness of the workshop, in order to prevent the seat from sinking and deformation.
机器底部若需垫料喷墨，必须采用抗压强度好的钢板，使底座尽量垫得紧实、均匀，不留大面积的“悬空”状况，防止受压变形。在垫、调机器的平行度过程中，机器的辊筒需反复用水平仪校调平衡北人股份，使整机处于比较水平的状态。
If inkjet is needed at the bottom of the machine, the steel plate with good compressive strength must be used to make the base as tight and uniform as possible without leaving a large area of "suspension" to prevent compression deformation. In the process of padding and adjusting the parallelism of the machine, the roller of the machine needs to adjust and balance the shares of Beiren repeatedly with the level meter, so that the whole machine is in a comparatively level state.