| 超声波压纹机安装 |
| 添加时间：2019/9/7 16:26:09 浏览次数： |
| 1. 拆卸包装，检查设备表面和各部分有无损伤的痕迹，检查螺丝是否松动，电气接头是否锁紧，配件是否齐全。 1. Disassemble the packaging, check the surface and parts of the equipment without any damage marks, check whether the screw is loose, whether the electrical joints are locked, whether the accessories are complete. 2. 设备应安放在平整的硬地面上，要求花边机背离热源至少0.5米，并要确保花边机前后至少有1米，左右至少有0.5米的空间，以便操作。 2. The equipment should be placed on the flat hard ground, requiring the lace machine to deviate from the heat source at least 0.5 meters, and ensuring that there is at least 1 meter before and after the lace machine and at least 0.5 meters of space around the lace machine for operation. 3. 核对发振箱背上标牌的电压要求，并要确保系统接地良好。 3. Check the voltage requirement of the sign on the back of the vibration box, and ensure that the system is well grounded. 4. 将设备与电源及气源连接，注意要先将电源开关关断。注意本机的电压要求：AC220V，50-60Hz 5. 空气管路接于干净且不含润滑剂的压缩空气源，额定工作气压为0.6MPa。 4. Connect the equipment with the power supply and the air source, pay attention to turn off the power switch first. Attention should be paid to the voltage requirements of this unit: AC220V, 50-60Hz 5. The air pipeline is connected to a clean compressed air source without lubricant, and the rated working pressure is 0.6MPa. |
| 上一页 木纹压纹机为新一代实木家具的最佳表面处理方式 |
| 下一页 PVC膜压纹机另一种方式是利用高频热能热合的方法 |
Copyright © 技术支持：遨游网络