| 压纹机开机操作步骤介绍 |
| 添加时间：2017/8/8 16:55:35 浏览次数： |
| 1、开启电源，检查压纹机托板位置，开启电脑，然后将托板位置归零 1. Turn on the power, check the position of the laminator, turn on the computer, and then return the support plate to zero 2、将深压纹机的加热系统打开，设置压纹机所需要的温度，提前打开温度 2. Open the heating system of the deep pressing machine and set the temperature required by the embossing machine to open the temperature in advance 3、检查所有的机械结构件是否在规定位置，将所有机械位置复位 3. Check whether all mechanical structures are in position and reset all mechanical positions 4、观看压纹机工作台内是否有异物，有异物需要及时清理，是否已经有压纹版 4. If there is any foreign body in the compressed machine table, there are foreign objects that need to be cleaned in time 5、打开液压油泵，查看油泵皮带是否松动，同时，手工将压纹机横梁升至最高处 5. Open the hydraulic oil pump to check whether the oil pump belt is loose. At the same time, the crossbar of the embossed machine can be reached to the highest point by hand 6、手工检查压纹机保护光幕是否正常，保护光幕是保护操作工人安全的，这一点非常重要 6. It is very important to check whether the stripper is normal to protect the light screen and protect the operation workers 7、液压系统一旦打开，就要开启压纹机冷却系统，特象机械深压纹机采用风冷，操作简单方便，按钮一下就可以了 7. Once the hydraulic system is opened, it is necessary to turn on the pressing machine cooling system. It is easy to operate the machine deep embossed machine, easy to operate and the button will be ready 8、装好深压纹版，同时灰纸板底模也做好，等压制十分钟将胶水固化的时候就可以校正套印精度，随机试验两张，如果套印没有问题，压纹版深浅没有问题的话就可以正常生产了! Version 8, packed deep embossing, gray paper also bottom die at the same time, while waiting for the suppression of ten minutes will glue curing can calibration accuracy, two randomized trials, no problem if overprint, embossing edition shades can be normal production without the word of the problem! |
| 上一页 压纹机开机操作步骤介绍 |
| 下一页 压纹机安装和调试工艺 |
Copyright © 技术支持：遨游网络