泰安通风管道知名厂

打开大罩壳，将减速机的注油孔和透气孔打开，加注32号齿轮油，注意观察减速机一侧的观察口，当油位到达观察口时即停止加油（冬天温度低，润滑油粘度大，加油过程时间长）。

Open the large housing, open the oil hole and vent hole of the reducer, add 32 gear oil, pay attention to observe the observation port on the side of the reducer, stop the oil when the oil level arrives at the observation port (low temperature in winter, large viscosity of the lubricating oil, long duration of the refueling process).

卸油口在观察口下方。换油的时候先打开透气帽，再打开卸油口螺丝，注意在螺丝快卸掉的时候放慢速度，防止油喷溅到身上。

The unloading port is below the observation port. When the oil is changed, open the air cap first, and then open the unloading screw. Notice that the speed is slowed down when the screw is unloaded quickly, so as to prevent the oil from splashing on the body.

压纹机与电源接线应牢固安全，接地线应牢固地接在接线盒内接地线柱上，并使机体外壳有良好的接地，电控线路中应安装与所选用电动机相配套的过载等保护装置。

The connection between the embossing machine and the power supply shall be firm and secure. The grounding wire shall be firmly connected to the grounding wire post in the junction box, and the body shell has good grounding.

接通电源，启动压辊检查其旋转方向是否正确。应特别注意接线后应点动试车，以防止闷烧电动机。

Connect the power supply and start the press roll to check whether the rotation direction is correct. Special attention should be paid to wiring after operating the motor to prevent the smoldering test.

空载和满载试运转时，压纹机运转平稳，无明显周期噪声，无渗漏润滑油现象。

When the test operation is empty and full load, the press stripe machine runs smoothly, there is no obvious periodic noise and no leakage lubricating oil phenomenon.

压纹机在首次加油后应先空转片刻，待运转正常后方可投料。长期停放后使用也应先空转片刻待运转正常后方可投料。

After the first refueling machine, the press should be turned for a moment for a moment. It should be used for a short period of time after long term parked.

物料的投放应缓慢、均匀，避免冲击载荷。

The delivery of materials should be slow and uniform, and the impact load should be avoided.

生产过程中，应尽量避免频繁起动和过载运行，压纹机一旦发生故障，应立即断电检查，予以排除。

In the process of production, it is necessary to avoid frequent starting and overload operation. Once the malfunction of the press, the blackout should be immediately checked and eliminated.