| 不准以压纹机代替砂轮机从事打磨作业 |
| 添加时间：2019/9/29 14:39:25 浏览次数： |
| 1、压纹在启动前应对电源闸刀开关、砂轮片的松紧度、防护罩或安全挡板进行详细检查，操作台必须稳固，夜间作业应有足够的照明，待确认安全后才允许启动。 1. Before starting, the embossing should check the tightness of the power switch, grinding wheel blade, protective cover or safety baffle in detail. The operating table must be stable, and enough lighting should be provided for night operation. Only after confirming the safety, can the embossing be allowed to start. 2、机械运转正常后，方准断料，断料时紧靠切割机的一头必须用夹具夹紧，然后手握切割机加力手把缓慢地向下加力，不能初割时突然加力，以免损坏切割砂轮片和砂轮片飞出伤人。 2. When the machine is in normal operation, it must be quasi-broken. When the material is broken, the end of the cutting machine must be clamped with a fixture. Then, the hand handle of the cutting machine should be grasped to exert force slowly downward, so that the abrupt force can not be applied at the beginning of cutting, so as to avoid damage to the cutting wheel and grinding wheel blade flying out and injuring people. 3、压纹25cm左右的短钢筋料时，需用夹具夹紧，不准用手直接送料，切割长钢筋时另一头需用人扶助，操作时动作要一致，不得任意拖拉，再切割料时，操作切割机人员不能正面对准砂轮片，需站在侧边，非操作人员不得在近旁停留，以免砂轮片碎裂时飞出伤人。 3. When pressing short steel bar about 25cm, clamp with fixture, no direct feeding by hand, the other end of cutting long steel bar should be supported by human, the operation should be consistent, no arbitrary dragging, and when cutting material, the operator of the cutting machine can not directly aim at the grinding wheel blade, must stand on the side, and the non-operator can not be nearby. Stay so that the grinding wheel fragments don't fly out and hurt people. 4、压纹工作完毕应关闸断电，锁好箱门，露天作业的应做好防雨淋的措施。 4. After the embossing work is completed, the gate shall be closed and the power shall be cut off, the box door shall be locked, and rain proof measures shall be taken for outdoor operation. 5、不准以压纹机代替砂轮机从事打磨作业。 5. It is forbidden to use embossing machine instead of grinding wheel machine to engage in grinding operation. |
| 上一页 压纹工作完毕应关闸断电，锁好箱门 |
| 下一页 木纹压纹机为新一代实木家具的最佳表面处理方式 |
Copyright © 技术支持：遨游网络